Quantitative analysis is used to determine the relative amount of each phase in a mixture, and is typically reported as Wt%. For this example, this mixture contains four crystalline phases; zincite, brucite, corundum and fluorite. The quantification of these phases was performed with Rietveld analysis which uses all lines in the pattern and produces an estimate of the errors on the weight percentage of each refined compound. Since Rietveld refinement uses the entire XRD pattern (all intensity), the percent of amorphous (non-crystalline) material can also be reported, so 100% of the material is accounted for.

Extensions of this refinement allow the determination of crystallite size and/or percent crystallinity, and m-stress can also be determined.

Although quantitative analysis is usually accomplished by Rietveld refinement, more accurate results can often be obtained by internal or external calibration methods, in which standards can be prepared over the narrow range of expected percentages. For simple relative comparison between samples, the RIR (Reference Intensity Ratio) method can be used.

Retained austenite on large steel parts can be measured non-destructively by our partner lab TEC.

 

What is the quantitative amount (ratio or wt %) of the phases in the material?

Quantitative Analysis

TEC07
TEC_Vector
quant-zin-bru-cor-fluorite

Quantitative Analysis

Crystalline Phase percentages are displayed; estimated errors(not shown)

Crystallite size of each phase and micro-strain, could be determined(not shown

Residual Pattern displayed

X-ray Wizards

An X-ray Diffraction Service Laboratory